Rogers Sampson Throne Clamp - Reproduction

Description

This is a reproduction of the Rogers Sampson throne clamp. This part is machined out of 2024 aluminum billet and should be stronger and last longer than the original cast part.
It has a couple of design changes which I hope doesn't detract from the 'vintage' aspect of the clamp. It is 1/8" taller which allows the part to have one additional thread for the center post which should add additional strength and wear resistance. Doing this also eliminated the strange recess located at the top of the original cast near the screw tabs which created a weak point where many of these parts broke. Also, the built in 'spacers' between the two halves can't be practically machined into this part so I'm adding a variety of external aluminum washers. I'm including 3 NON-ROGERS hex screws with this clamp which are essentially place holders in the event you don't have the original ones. There are reproductions of the Rogers set/pull screws sold elsewhere.
USPS First Class postage to CONUS only -